FIBARO Single Relay Switch
Cena: 6,318.00 RSD
Bez PDV-a: 5,265.00 RSD
Bez PDV-a: 5,265.00 RSD
FIBARO Relay Switch is designed to be installed in standard wall switch boxes or anywhere else where it is necessary to control an electric device drawing up to 2500W.
As with all other Actors, FIBARO Relay Switch allows to control connected devices either via the Z-Wave network or via a switch connected directly to it.
As with all other Actors, FIBARO Relay Switch allows to control connected devices either via the Z-Wave network or via a switch connected directly to it.
- Compatible with any Z-Wave Controller
- Advanced microprocessor control
- Executive element – electromagnetic, micro-gap relay switch
- May be oparated by momentary or toggle switches
- To be installed in wall switch boxes of dimensions allowing for installation, conforming to provisions of applicable regulations
Read this manual before attempting to install the device!
Failure to observe recommendations included in this manual may be dangerous or cause a violation of the law. The manufacturer, Fibar Group S.A. will not be held responsible for any loss or damage resulting from not following the instructions of operating manual.
Danger of electrocution!
The device is designed to operate in electrical home installation. Faulty connection or use may result in fire or electric shock.
All works on the device may be performed only by a qualified and licensed electrician. Observe national regulations.
Even when the device is turned off, voltage may be present at its terminals. Any maintenance introducing changes into the configuration of connections or the load must be always performed with disabled fuse
Required overcurrent protection
The device must be protected with an overcurrent protection (fuse) with a value not higher than 10A.
| Power supply: | 110-240 V AC, 50/60 Hz |
| Rated load current (resistive load): | 10A total current |
| Power consumption: | up to 0.8W |
| Power output (resistive load): | 2500W for 240V AC 1250W for 120V AC |
| In accordance with EU standards: | RED 2014/53/EU RoHS 2011/65/EU |
| Operational temperature: | 0-35°C |
| Active element: | micro-gap relay switch μ |
| Durability (resistive load, 6.5A): | 200 000 switches |
| For installation in boxes: | Ø ≥ 50mm, depth ≥ 60mm |
| Radio protocol: | Z-Wave |
| Radio signal power: | up to 1mW |
| Radio frequency: | 868.4 MHz EU; 908.4 MHz US; 921.4 MHz ANZ; 869.0 MHz RU; 865.2 MHz IN; |
| Range: | up to 50 m outdoors up to 30 m indoors (depending on building materials) |
| Dimensions: (L x W x H)): | 42.50 x 38.25 x 20.30 mm |
-
FGS-212-EN-A-v1.1
-
Fibaro Smart Home 2016
Slicni proizvodi:
